Complete automation kit for self-supporting gates PNI AP800C, motor, wheels, photocells, remote control, lamp, 6 meters of rack, 3x2 m rail for a useful opening of 4-5m, 230V, 1100 N and 800KG sliding

Self-supporting gate automation system

The self-supporting gate opening automation kit is equipped with a 350W motor that can open or close gates with a maximum weight of 800 kg. The PNI AP800C gate automation kit includes all the components necessary to put a practical access control system into operation: the motor, warning light, two photocells, 6 meters of rack, wheel kit and mounting accessories kit.

Remote control

The gate can be opened and closed remotely or other access control devices such as access buttons or access keypads can be connected to the system.

Obstacle detection

To avoid accidents, two sensitivity levels can be set: high and low. If the gate is closing or opening and encounters an obstacle, the motor will stop.

Automatic closing

The gate can be programmed to close automatically after a certain number of seconds (10, 30 or 60). It can also be programmed to have condominium mode, which allows simultaneous control from multiple access devices. In condominium mode, when the gate is opening, if the buttons on the remote control or another connected access terminal (access button or access keypad) are pressed, they will not work until the gate is fully open. When the gate is closing, if the buttons on the remote control or another connected access terminal are pressed, the gate will stop and open fully, allowing access.

Installation precautions

Do not weld when:

- this is mounted on the bearing sets (the bearing contact is damaged);

- the engine is mounted (it leads to the failure of the board and the wiring on it).